Removing Carpet Stains & Spots : How to Clean Blood From Carpet

13 views

My BlogWith a little patience, you can use any of the 5 ways shown below to completely wipe out the blood stains from your carpet: Method 1: Using cold…
If you are unfortunate enough to encounter blood on your carpet, it really is not the end of the world. I have three methods on how to get bloodSteps. Blot with a clean, white cloth or towel. Press down and lift to pick up as much wet blood as possible. Spray with cold water. Keep wetting and blotting. Treat with salt paste. Wet with dilute liquid detergent. Turn on a fan to speed up drying. Vacuum or brush the dry carpet.
ll you need to do now is remove the salt residue from the carpet. Let the area dry and vacuum up the dry salt.Mix one tablespoon of scent-free liquid hand dishwashing detergent with two cups of cold water. If the stain has dried,put a brush to it to remove deposit. Using a clean white cloth, sponge the stain with the detergent solution. Blot until the liquid is absorbed.Blood stains can be especially difficult to remove because the hemoglobin in the blood acts as a binder when it contacts oxygen and binds with the material in …
Unfortunately, a set in blood stain is always hard to get out. You are lucky if your stain is still fresh and it has not permanently settled into the carpet. It will be …
Blot up the blood with a clean white cloth or paper towel by putting downward pressure on the affected area. Don’t wipe from side to side as it will spread the …

Okay, now we are going to be getting bloodout of carpet fibers.

The first thing you want to know about blood is how long it’sbeen there, because you want to get it up as immediately as possible.

The first thingyou want to do is you want to blot the blood off the carpet fiber to get as much excessas you can, it’s fresh.

The next you want to do is you want to flood the area with ammonia.

And you want to blot it again.

I’m going to use a paper towel so the blood doesn’t transferin cloths unless you have a rag that you don’t care about that’s fine.

So, now that thathas been blotted you want to add a little bit of water, cold water, and preferably saltwater, so I’ll just add a little bit of salt to the mixture.

And water again to dissolvethe salt into the stain.

Then you want to add a little bit of dish soap.

And you wantto let it sit for a good hour, to allow the blood to dissolve, and then when you comeback after an hour, you want to blot it and then you want to flood the area with justcold water.

Usually you use cold water to get out most stains because heat has a tendencyof setting a stain into the carpet fibers.

There are some cases when you would use lukewarmwater or in very rare cases, warm water.

So once you flood the area again, you can blotit a final time and that should lift the stain completely off the fibers and if it doesn’tthen you can just repeat the steps to get the remaining amount off.

Source: Youtube

Tags: #: #& #blood #carpet #Clean #from #how #remove #Removing #Spots #stains #to